![]() This DTC runs continuously within the enabling conditions.The intake air temperature (IAT) is between -7 to +125☌ (+19 to +257☏).The engine coolant temperature (ECT) is between 70-125☌ (158-257☏).The engine speed is between 400-6,400 RPM.If the ECM detects that the MAP sensor input is not within a calibrated limit of the estimated value, DTC P0106 sets.ĭTC DescriptorThis diagnostic procedure supports the following DTC:ĭTC P0106 Manifold Absolute Pressure (MAP) Sensor Performance ![]() The diagnostic compares the estimated values to the actual sensor inputs. Calibrated within the diagnostic are estimates for the MAP, the mass air flow (MAF), and the throttle position (TP) for all engine operating conditions. Within the ECM, the intake flow rationality diagnostic has the ability to determine an inaccurate input from the three systems it monitors. The MAP can range from 10 kPa when pressures are low to as much as 104 kPa when pressures are high, depending on the BARO. The lowest manifold pressures occur when the vehicle is idling or decelerating. Under these conditions, the ECM uses the MAP sensor to determine the current BARO. This occurs when the vehicle is operated at wide open throttle (WOT), or when the ignition is ON while the engine is OFF. Under normal operation, the highest pressure that can exist in the intake manifold is equal to the BARO. The ECM converts the signal voltage input to a pressure value. The MAP sensor provides a signal voltage to the ECM, relative to the pressure changes on the MAP sensor signal circuit. The ECM supplies a ground on a low reference circuit. The engine control module (ECM) supplies a regulated 5 volts to the sensor on a 5-volt reference circuit. The MAP sensor wiring includes three circuits. The sensor translates this action into electrical resistance. ![]() ![]() A diaphragm within the MAP sensor is displaced by the pressure changes that occur from the varying load and operating conditions of the engine. Pressure in the intake manifold is affected by engine speed, throttle opening, air temperature, and barometric pressure (BARO). The manifold absolute pressure (MAP) sensor measures the pressure inside the intake manifold. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |